Advertisement
Installation
After threading the coaxial cables connected to the terminal board
through points 1 and 2 as shown at right, replace the jack panel
on the main unit.
1 1 Pass the cable through the oval-shaped hole.
2 2 Pull the cable out from the position shown.
(AJ-DE77 only)
Remove the two screws and two hexagonal bolts of the AV
interface connector at the bottom rear of the Quick Cutter and
remove the TRV interface board together with its metal clamp.
(AJ-DE77 only)
Remove the four screws securing the TRV interface board and metal clamp,
and replace the board with the accessory TRV interface board, then use the
four screws to secure the metal clamp.
(AJ-DE77 only)
Use two screws and two bolts to secure the metal clamp, which was
attached to the TRV interface board, to the Quick Cutter unit.
AV I/F
Screws (x2)
Hexagonal bolts (x2)
-4-
Enlarged view
Screws (x4)
Screws (x2)
Hexagonal bolts (x2)
Advertisement
