2.2 PT Programming—Procedures
Conditions
•
The numbers of outside (CO) line ports that do not have lines connected should be set to "Not
connect". The PBX seizes the highest available outside (CO) line number when selecting an idle
outside (CO) line automatically. If an unconnected outside (CO) line number is set to "Connect"
and is numbered higher than any connected outside (CO) line number, the PBX will try to seize the
unconnected outside (CO) line.
Feature Manual References
1.1.71 Line Access, Outside (CO) Line—SUMMARY
1.1.76 Line Preference—Outgoing
[401] Dial Mode
Selects the type of signal used to dial out using an outside (CO) line.
4
0
1
Programming Manual References
[402] Pulse Speed
Feature Manual References
1.1.39 Dial Type Selection
[402] Pulse Speed
Selects the speed at which pulse signals are sent to the outside (CO) lines for which Dial Mode in [401] Dial
Mode is set to "Pulse" or "Call Blocking".
4
0
2
Programming Manual References
[401] Dial Mode
Feature Manual References
1.1.39 Dial Type Selection
38
Programming Manual
NEXT
CO line no.
NEXT
(1 ... 8/
)
NEXT
CO line no.
NEXT
(1 ... 8/
)
( Low Speed: 10 pps/
or
PREV
To continue
name*
SELECT
STORE
( DTMF/Pulse/
Call Block mode)
To continue
SELECT
or
PREV
To continue
name*
SELECT
STORE
High Speed: 20 pps)
To continue
SELECT
END
END