Quick Setup - Panasonic KX-TA824 Programming Manual

Advanced hybrid system
Hide thumbs Also See for KX-TA824:
Table of Contents

Advertisement

8.2

Quick Setup

Allows basic settings of the PBX to be modified easily.
This option can be accessed in either of 2 ways:
Automatically when connecting to the PBX for the first time or after the PBX data has been cleared.
Manually, by selecting Quick Setup from the Utility menu.
This option only runs automatically when the following conditions are met:
The user is logged on to Maintenance Console using the Installer level programmer code.
The date and time of the PBX have not yet been set.
The model code of Maintenance Console and PBX match.
The user has selected to connect Maintenance Console to the PBX in Interactive mode.
It can be run manually when the following condition is met:
Maintenance Console is connected to the PBX in Interactive mode.
When the Quick Setup wizard is started manually, it is possible to cancel the wizard at any point by clicking
the Cancel button. No changes will be made to the PBX. However, the Cancel button is not available when
Quick Setup runs automatically upon connection to the PBX. In addition, when Quick Setup runs, it shows
only default data for all programmable parameters. Any existing settings are not shown, and will be
overwritten, so run Quick Setup manually only when necessary.
Using Quick Setup, the following basic parameters can be programmed as desired:
The date and time. The PBX uses the date and time set to the PC. (→ 9.1.1 Date & Time [1-1])
The system password. (→ 9.1.2 Main [1-2])
The operator extension number. (→ 1.1.87 Operator/Manager Features in the Feature Manual)
Automatic Configuration for CO Line Type (DTMF/Pulse). (→ 1.1.5 Automatic Configuration for
Outside (CO) Line Type in the Feature Manual)
Extension numbers and names. (→ 1.1.69 Intercom Call in the Feature Manual)
Ringing assignment for each outside line (either all extensions, or a specific extension). (→ 1.1.90
Outside (CO) Line Ringing Selection in the Feature Manual)
While downloading system data from the PBX
The Firmware Upgrade screen will be displayed automatically. Reselect the system
software file and perform the upgrade again.
While writing the new software to the PBX
The PBX will be unable to start properly. The Firmware Upgrade screen will be
displayed automatically. Reselect the system software file and perform the upgrade
again.
While restoring system data to the PBX
The Firmware Upgrade process will be automatically restarted from this step, and
system data will be restored to the PBX.
8.2 Quick Setup
Programming Manual
113

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kx-ta624

Table of Contents