Troubleshooting; During Installation; Reset Button - Panasonic EASA-PHONE KX-T30810 Installation Manual

Extension does not operate.
Improper reset operation
Call is disconnected during
connection operation
Noise in external paging
Volume distortion from
external music source
Speed dialing or One Touch
Dialing does not function.
A dial tone (short tone
continuously) was heard
and telephone line hung up
af once when accessing a
outside during the
speakerphone mode.
Bad connection between
system and extension
The system progratn switch
of the KX-T30810 is set to
PROGRAM.
A telephone with an A-Al
relay is connected.
Bad exfension
Instantaneous drop of DC
voltage frotn Central OfJice
(or host PBX) when in
operation of connection
between C. 0. and system.
Induced noise on the wire
between System and at7
Amplifier.
Excessive input level from
external music source
Bad programming
The host PBX may cause
the line to hang up whet? the
KX- T30810 was connected
to it.
5-l
Take thar extension and plug it into the same
extension port using a short telephone cord.
lf telephone does not work, connection between the
system and rhe exxtetzsion must be repaired.
Set to SET except when programming.
Use a 2 wires cord.
Set the A-Al relay switch of rhe telephone to
OUT or OFF.
Take that extension and plug it into anothet
extension port that is working. If the telephone
does not work, replace rhe phone.
Press the Reset Button.
Progratn for a no CPC signal (CPC means
Culling Parry Control)
Set the calling party control signal to
"DISABLE".
Refer to page 2-28.
Use a shielded cable as a connection wire between
Systetn and Amplifier.
A shorter shielded cable is recommended.
reuse the Output level of the external music
source by using the Volume Control on rhe
tnusic source.
Enter the line access code (9, 81, 82, 83) into
programming.
Use the handset instead of the speakerphone