Calling Party Control (Cpc) Signal - Panasonic EASA-PHONE KX-T30810 Installation Manual

A=[*]:
to assign the same
on
a113 CO's
-a:ar;
until the desired mode appears
[20] [NEXT] [i4] [SELECT] [MEMORY] [END]
~][NEXT][NEXTI(SELECT][MEMORY][ENDI
.-.---- until the desired CO number appears
To detect that an outside party has hung up and
then terminate the outside
(after a
conversation,
conference etc.) a CPC signal is needed.
CPC signal can be removed or added at
customer's request.
1. Dial (20).
"CPC DETECTION" will be displayed.
2. Press the NEXT button.
"ENTER CO NO" will be displayed.
3. Press the NEXT button.
"CO 1: ENABLE" will be displayed and
"ENABLE" will blink.
. Press the SELECT button, to alternate be-
tween ENABLE and DISABLE to select the
desired mode.
5. Press the MEMORY button.
The blinking LCD will stop.
2-28
. Repeat steps 3 to 5, to program the assign-
ment of the other CO's.
7. To return to the initial program mode, press
the END button.
s
ou start the programming from step 1,
you may dial the desired CO number instead
e NEXT button at step 3.
PREV button allows you to go to the
previous CO for displaying the calling party
control
signal selection.
&
See page 5-16.