During Operation; Reset Button - Panasonic EASA-PHONE KX-T30810 Installation Manual

Extension does not operate.
When speakerphone mode,
nothing is heard.
The unit does not ring.
During a power interruption
extensions II,12 and 13 do
not operate.
The Power failure switch
of
the KX- T30830 is set to ON.
The HANDSETI
HEADSET selector of the
KX- T30830 is set to the
"HEADSET'position.
Ringer Volume Selector is
set to "OFF".
The Power failure switch
of
the KX- T30830 is set to
OFF.
The dialing mode (tone or
pulse) is improper.
KX- T30820 or
KX-T30850 is connected.
Set the Power.failure switch to OFF.
When the headset is not used, set the HANDSETI
HEADSETselector to the "HANDSET" position.
Set to "HIGH" or "LOW".
Set the Power failure switch to ON.
Set the ToneiPulse switch to the other position.
Disconnect the KX-T30820 or KX-T308.50 and
connect the KX-T30830 or a standard telephone.
If
the system is not operating properly, use the Reset
Button.
Before using Reset Button, try again the system
feature which does not work several times to
confirm there definitely a problem.
Pressing the Reset button will cause the followings.
1. Camp-on to be cleared.
2. Last number redial to be cleared.
3. Saved number redial to be cleared.
4. Calls on hold are terminated.
5. Calls on exclusive hold are terminated.
6. Calls in progress are terminated.
Data that is stored in memory other than above
mentioned will not be cleared by use
of
the Reset
Button.
Note
If
the system does not operate properly,
p~lsh
the
Reset Button.
If
still no difference occurs, switch the power
off
and
on again after 5 minutes.
If
the system still does not
work, switch the power
off.
The following extensions will be directly connected
to each of the central office lines (C.O.).
Extension ll...C.O.l
Extension 12.. .C.O.2
Extension 13...C.O.3
If
the KX-A16 is connected to the system, switch
off
the power
of
the KX-A16.
5-3