TP-Link JetStream TL-SL3428 User Manual page 75

LeaveAll Timer:
Join Timer:
Leave Timer:
LAG:
Note:
LeaveAll Timer >= 10* Leave Timer, Leave Timer >= 2*Join Timer
Configuration Procedure:
Step Operation
1 Set the link type for port.
2 Enable GVRP function.
3 Configure the registration
mode and the timers for the
port.

Fixed: In this mode, a port cannot register/deregister a VLAN
dynamically. It only propagates static VLAN information.

Forbidden: In this mode, a port cannot register/deregister
VLANs. It only propagates VLAN 1 information.
Once the LeaveAll Timer is set, the port with GVRP enabled can send
a LeaveAll message after the timer times out, so that other GARP
ports can re-register all the attribute information. After that, the
LeaveAll timer will start to begin a new cycle. The LeaveAll Timer
ranges from 1000 to 30000 centiseconds.
To guarantee the transmission of the Join messages, a GARP port
sends each Join message two times. The Join Timer is used to define
the interval between the two sending operations of each Join
message. The Join Timer ranges from 20 to 1000 centiseconds.
Once the Leave Timer is set, the GARP port receiving a Leave
message will start its Leave timer, and deregister the attribute
information if it does not receive a Join message again before the
timer times out. The Leave Timer ranges from 60 to 3000
centiseconds.
Displays the LAG to which the port belongs.
Description
Required. On the VLAN→802.1Q VLAN→Port Config
page, set the link type of the port to be TRUNK.
Required. On the VLAN→GVRP page, enable GVRP
function.
Required. On the VLAN→GVRP page, configure the
parameters of ports basing on actual applications.
68
Return to CONTENTS