Rear Panel - TP-Link JetStream TL-SL3428 User Manual

Note:
When using the SFP port with a 100M module or a gigabit module, you need log on to the GUI
(Graphical User Interface) of the Switch and configure its corresponding Speed and Duplex mode
on Switching→Port→Port Config page. For 100M module, please select 100MFD while select
1000MFD for gigabit module. By default, the Speed and Duplex mode of SFP port is 1000MFD.

2.3.2 Rear Panel

The rear panel of TL-SL3428 features a power socket and a Grounding Terminal (marked with ).
 Grounding Terminal: TL-SL3428 already comes with Lightning Protection Mechanism. You
can also ground the Switch through the PE (Protecting Earth) cable of AC cord or with Ground
Cable. For detail information, please refer to Quick Installation Guide.
 AC Power Socket: Connect the female connector of the power cord here, and the male
connector to the AC power outlet. Please make sure the voltage of the power supply meets the
requirement of the input voltage (100-240V~ 50/60Hz 0.6A).
Figure 2-2 Rear Panel
8
Return to CONTENTS