TP-Link JetStream TL-SL3428 User Manual page 106

The following entries are displayed on this screen:
Multicast VLAN

Multicast VLAN:
VLAN ID:
Router Port Time:
Member Port Time:
Leave Time:
Static Router Port:
Note:
1. The router port should be in the multicast VLAN, otherwise the member ports can not receive
multicast streams.
2. The Multicast VLAN won't take effect unless you first complete the configuration for the
corresponding VLAN owning the port on the 802.1Q VLAN page.
3. The link type of the member ports in the multicast VLAN can only be GENERAL.
4. Configure the link type of the router port in the multicast VLAN as TRUNK or configure the
egress rule as TAG and the link type as GENERAL otherwise all the member ports in the
multicast VLAN can not receive multicast streams.
Figure 8-7 Multicast VLAN
Select Enable/Disable Multicast VLAN feature.
Enter the VLAN ID of the multicast VLAN.
Specify the aging time of the router port. Within this time, if the
switch doesn't receive IGMP query message from the router port,
it will consider this port is not a router port any more.
Specify the aging time of the member port. Within this time, if the
switch doesn't receive IGMP report message from the member
port, it will consider this port is not a member port any more.
Specify the interval between the switch receiving a leave message
from a host, and the switch removing the host from the multicast
groups.
Select the static router port which is mainly used in the network
with stable topology.
99