Walk Test; Allowing Computer Access To Your System - DSC Impassa User Manual

NOTE: Only use Energizer (4) 1.5V AA alkaline batteries (WT5500, WT4901/WT8901).
DO NOT RECHARGE THESE BATTERIES. DISPOSAL OF USED BATTERIES MUST BE MADE IN
ACCORDANCE WITH THE WASTE RECOVERY AND RECYCLING REGULATIONS IN YOUR AREA.

22.2 Walk Test

Walk Test mode allows you to test the operation of each detector in the system. While in Walk Test
mode, the Ready, Armed, and Trouble LED's will flash to indicate that the Walk Test is active. The
Walk Test can be terminated at anytime by re-entering [
system will also automatically terminate the Walk Test on completion; it will sound an audible warn-
ing (5 beeps every 10 seconds), beginning 5 minutes before the termination of the test.
1. Before testing, ensure that the system is disarmed and the Ready light is on.
2. Press [#] and close all zones to return the system to the Ready state.
3. Perform a System Test by following the steps in the previous section.
4. Press [ ][6][Master Code][8] to initiate the Walk Test.
,
5. To test the zones, activate each detector in turn (e.g., open each door/window or walk in motion
detector areas). The System will display the following message "Secure System Before Arming <
>", or "Secure or Arm System" when each zone (detector) is activated. Use the [<][>] buttons to
view which zones are open. The message will disappear when the zones are closed.

22.3 Allowing Computer Access to your System

Occasionally, your installer may need to send information to or retrieve information from your secu-
rity system. Your installer will do this by having a computer call your system. You may need to pre-
pare your system to receive this downloading call.
To do this: Press [ ][6][Master Code][5] at the keypad. This allows downloading for a limited period
,
of time. During this time, the system will answer incoming downloading calls. For more information
on this feature, please ask your installer.
][6][Master Code][8] on the keypad. The
,
16