Disarming The System - DSC Power832 PC5015 Instruction Manual

Quick Exit
When the Quick Exit feature is enabled, pressing [ ][0] while the system is armed will provide a two
minute window for you to exit the premises. During this time, you may only open and close the
designated Entry/Exit door once. Once the door is closed, the panel will end the two minute quick exit
delay. If the door is opened again, or if the door is not closed after two minutes, or if another zone is
opened, the panel will begin the entry delay. Your installer will inform you if the Quick Exit feature has
been enabled on your system.

Disarming the System

Disarming from an LED Keypad:
Enter the premises through a designated Exit/Entry door; entering by any other door will sound an
immediate alarm. As soon as the Exit/Entry door is opened, the keypad will beep to indicate that the
system should be disarmed. Go to the keypad and enter your access code. If an error is made
entering the code, enter your code again. As soon as the correct code is entered, the Armed light will
go out and the keypad will stop beeping.
The correct access code must be entered before the entry delay period expires. If a valid access code
is not entered during this time, the system will go into alarm. The entry delay time may be changed by
your installer.
If an alarm occurred while the system was armed, upon disarming the system, the Memory light and the
zone light corresponding to the zone which caused the alarm will flash for 30 seconds. After the 30
second period, the Memory light and zone light will stop flashing and the panel will return to the Ready
state. Pressing the [#] key during the 30 second period will cancel the alarm memory display. To view
other alarms, press [ ][3].
If a trouble was detected when the panel is disarmed, the Trouble light will turn ON (See "Viewing
Trouble Conditions" on page 12 to determine the source of the trouble.) Please note that troubles will
not display while the system is in the Alarm Memory Display mode.
Disarming from an LCD Keypad:
Upon entering through a designated Exit/Entry door, the keypad will beep and the entry delay will
commence, reminding you to disarm the system. The keypad will display the following message...
Enter your access code. If an error is made in entering the code, enter the code
Entry Active
again. When a valid access code is entered, the keypad will stop beeping. If no
Enter Your Code
alarms occurred while the panel was armed, and there are no troubles, the display
will read...
After about five seconds, the system will return to the Ready state and the display will
System Disarmed
read...
No Alarm Memory
Enter Code to
Arm System
If an alarm occurred while the system was armed, this message will be displayed.
View Memory < >
Use the arrow (< >) keys to view which zones caused the alarm. If a zone is still in
"Zone of Alarm"
alarm, the display will show the following message to indicate that a zone is open...
Secure System
Before Arming <>
Upon disarming and if a trouble is present, this message will be displayed. Use the
Enter Code to
arrow (< >) keys to view which troubles are affecting the system (see "Viewing
Arm System < >
Trouble Conditions" on page 12).
6