Operation - Dimplex SYMPHONY SF5598 Parts & Service Manual

SYMPHONY ELECTRIC FIREPLACE

OPERATION

This section will explain the function of each convent control.
To access the controls, open the upper grill by pulling near the top, forward
and down.
A. MAIN ON/OFF SWITCH
The on/off switch supplies power to all fireplace functions (heater & flame).
B. FLAME SPEED CONTROL (not available on some models)
Turn the flame speed control knob to adjust the flame speed to the desired
level.
C. FLAME LIGHT DIMMER CONTROL
Turn the flame brightness control to increase or decrease the brightness
of the flame and embers.
D. HEATER ON/OFF SWITCH
The heater on/off switch supplies power to the heating unit when the main
on/off switch (A) is in the on position.
E. HEATER THERMOSTAT CONTROL
To adjust the temperature to your individual requirements, turn the
thermostat control clockwise all the way to turn in the heater. When the
room reaches the desired temperature, turn the thermostat knob counter
clockwise until you hear a click. Leave in this position to maintain the
room temperature at its setting. For additional heat, turn clockwise until
you hear the click again and the heater will turn on. To turn the heater off,
rotate the knob fully counter clockwise.
RESETTING THE TEMPERATURE CUTOFF
This unit is equipped with a thermostat which controls the temperature of
the room. It does this by turning the heater on and off. The heater is
protected with a safety device to prevent overheating. Should the heater
overheat, an automatic cut out will turn the heater off and it will not come
back on without being reset. It can be reset by switching the ON/OFF
SWITCH to OFF and waiting 5 minutes before switching the unit back on.
CAUTION
If you need to continuously reset the heater, unplug the unit and call your
local dealer.
3