To Replace Flame Speed Control - Dimplex SYMPHONY SF5598 Parts & Service Manual

SYMPHONY ELECTRIC FIREPLACE
If the fireplace was operating prior to servicing allow at least 10 minutes for light
bulbs and heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the
risk of electric shock or damage to persons.

TO REPLACE FLAME SPEED CONTROL

1. Remove the firebox trim by placing your hand on the grill section, grasping
the trim and pulling outwards releasing the retainer clips.
2. Remove the firebox from the mantel.
3. Lower the grill covering the controls.
4. Remove the retaining screws on the top cover and remove the top, placing
it upside down on the top of the unit being careful not to damage any of
the wiring.
5. Locate the flame speed control mounted on the top panel and disconnect
the wiring clips and connections noting their original locations.
6. Pull off the thermostat control knob to expose the mounting nut.
7. From under the panel, break off the four mounting studs on the flame
speed control by grasping with pliers and twisting on the protruding part of
the stud, push the remainder of the studs out through the top panel. New
mounting studs are supplied with the replacement speed control.
8. Properly orientate the new flame speed control and connect all of the
wiring connections.
9. Reassemble in the reverse order as above.
11