To Replace The Power Cord - Dimplex SYMPHONY SF5598 Parts & Service Manual

SYMPHONY ELECTRIC FIREPLACE
If the fireplace was operating prior to servicing allow at least 10 minutes for light
bulbs and heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the
risk of electric shock or damage to persons.

TO REPLACE THE POWER CORD

1. Remove the firebox trim by placing your hand on the grill section, grasping
the trim and pulling outwards releasing the retainer clips.
2. Remove the firebox from the mantel.
3. Lower the grill covering the controls.
4. Remove the retaining screws on the top cover and remove the top, placing
it upside down on the top of the unit being careful not to damage any of
the wiring.
5. Locate and disconnect the power cord wiring connections noting their
original locations.
6. With needle nose pliers grasp the power cord strain relief grommet from
inside the rear panel and push while twisting to remove.
7. Pull the power cord out through the hole in the rear cover.
8. Install the new power cord through the hole in the rear cover and connect
all of the wiring connections in their original locations.
9. Install the power cord strain relief grommet on the power cord and insert
into the hole in the rear cover.
10. Reassemble in the reverse order as above.
17