To Replace Power Cord - Dimplex Contempra KDS6401E Parts & Service Manual

KDS6401E
If the stove was operating prior to servicing allow at least 10 minutes for light bulbs and
heating element to cool off to avoid accidental burning of skin.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of
electric shock or damage to persons.

TO REPLACE POWER CORD

1. Remove the stove pipe kit (if equipped).
2. Remove the four screws from the rear panel and remove.
3. Locate and remove the wiring connections for the power cord.
4. With needle nose pliers grasp the power cord strain relief grommet from inside the
bottom cover and push while twisting to remove.
5. Pull the old power cord out through the bottom cover.
6. Install the new power cord through the hole in the bottom cover and connect all of
the wiring connections in their original locations.
7. Install the power cord retaining grommet on the power cord and insert into the hole
in the bottom cover.
8. Reassemble in the reverse order as above.
14