Dimplex DF2608 Owner's Manual page 15

Maintenance
clockwise.
12. replace light filter bracket
and flicker rod.
13. Install the log set assembly by
placing the front, bottom edge
of the ember bed in the track
behind the control panel.
once in place, push down on
the back edge of the ember
bed until the rear tab snaps
into place under the mirror
(Figure 8).
!
NOTE: Ensure the log set
Assembly is installed tightly under
the bottom edge of the mirror to
prevent light leakage.
14. Lay unit on it's back and slide
Front Glass back into position
Figure 9
Flicker rod
Light Block
Light Filter
Bracket screws (2)
and attach trim.
Upper Light Bulb Requirements
Quantity of two (2) clear
chandelier or candelabra bulbs
with an E-12 (small) socket base,
15 Watt rating.
Do not exceed 25 Watts per
bulb.
To access the upper light bulb
area:
1. slide fireplace out of mantel.
2. Lay unit on it's back for safe
removal of front glass.
3. Remove three (3) Phillips
screws from right side of trim.
4. remove trim.
5. Slide glass to the right side
Light Block screws (4)
Lower Light
Bulbs (3)
15