Volvo XC90 Owner's Manual page 183

07 Wheels and tyres
Emergency puncture repair*
10. Switch off the compressor to check the
pressure on the pressure gauge. Minimum
pressure is 1.8 bar and
maximum is 3.5 bar.
11. Switch off the compressor and unplug the
cable from the 12 V socket.
12. Detach the hose from the tyre valve and fit
the valve cap.
13. As soon as possible, drive
approximately 3 km at a maximum speed
of 80 km/h so that the sealing fluid can seal
the tyre.
Rechecking the repair and pressure
1. Reconnect the equipment.
2. Read the tyre pressure on the pressure
gauge.
3. If it is below 1.3 bar then the tyre is insuf-
ficiently sealed. The journey should not be
continued. Contact a tyre centre.
4. If the tyre pressure is higher than 1.3 bar
then the tyre must be inflated to the pres-
07
sure specified on the tyre pressure label.
Release air using the pressure reducing
valve if the tyre pressure is too high.
*
182
Option/accessory, for more information, see Introduction.
WARNING
Do not unscrew the bottle, it is equipped
with a reverse catch to prevent leakage.
5. Switch off the compressor. Detach the air
hose and cable. Refit the dust cap.
NOTE
The sealing fluid bottle and hose must be
replaced after use. Volvo recommends that
you contact an authorised Volvo workshop
for checking if you are uncertain about tread
depth.
WARNING
Check the tyre pressure regularly.
6. Return the emergency puncture repair kit
to the cargo area.
7. Volvo recommends that you drive to the
nearest authorised Volvo workshop for the
replacement/repair of the damaged tyre.
Advise the workshop that the tyre contains
sealing fluid.
WARNING
You should not drive faster than80 km/h
after the emergency tyre repair kit has been
used. Volvo recommends that you visit an
authorised Volvo workshop for inspection of
the sealed tyre (maximum driving distance
is 200 km). The staff there can determine
whether or not the tyre can be repaired or if
it needs to be replaced.
Inflating the tyres
The car's original tyres can be inflated by the
compressor.
1. The compressor must be switched off.
Make sure that the switch is in position 0
and locate the cable and air hose.
2. Unscrew the wheel's dust cap and screw
in the air hose valve connection to the bot-
tom of the thread on the tyre's air valve.
WARNING
Do not leave children in the car without
supervision when the engine is running.