Router Configuration; Step 1: Determining The Ip Addresses Of Home Router And Visonic Powerlink2 - Visonic PowerLink2 User Manual

Programming for Configuring Events Reporting to Central Stations
Follow the instructions below to select the type of events to be reported and to
determine the method used for reporting events.
1. From the PowerMax control panel, enter "INSTALLER MODE" menu using the
Installer Code.
2. Enter the "5.DEFINE COMM." menu.
3. Enter the "3:C.S.REPORTING" sub-menu.
4. Program the following menus:
• "REPORT EVENTS" – Select the type of events that the control panel will
report to the Central Station.
st nd rd
• "1 /2 /3 REPORT METHOD" – Define the 1
to report events. Select the "broadband" option for PowerLink2.
• "IP RCVR 1/2" – Enter the Central Station IP address the PowerLink2 will
report to (not mandatory field).

Router Configuration

After installing the hardware you need to configure the Home Router. Different Home
Router models have different login interfaces and configuration. The following
section includes a general description of the procedure and an example of a specific
Home Router model. Router specific instructions and guides for port forwarding can
be found at http://www.portforward.com.
Step 1: Determining the IP Addresses of Home Router and Visonic
PowerLink2
1. Make sure you have in front of you the Visonic PowerLink2 Installation Form
- see appendix B.
2. On your PC click Start > Run.
In the Open text box type cmd and click OK.
3.
4. At the Command Prompt type ipconfig and press Enter
Installing the Visonic PowerLink2
st nd rd
/2 /3
13
priority of method used