Router Configuration - Visonic PowerLink User Manual

Step 3: Wall Mounting the Visonic PowerLink

Router Configuration

After installing the hardware you need to configure the Home Router. Different Home
Router models have different login interfaces and configuration. The following
section includes a general description of the procedure and an example of a specific
Home Router model. Router specific instructions and guides for port forwarding can
be found at http://www.portforward.com.
Step 1: Determining the IP Addresses of Home Router and Visonic
PowerLink
1. Make sure you have in front of you the Visonic PowerLink Installation Form -
see appendix A.
2. On your PC click Start > Run.
3. In the Open text box type cmd and click OK.
4. at the Command Prompt type ipconfig and press Enter
Mark and drill 3 holes in mounting
1
surface. Fasten the bracket to the
mounting surface with the screws.
3
Fasten bracket
to the
PowerLink
17
Installing the Visonic PowerLink
2
Locate PowerLink
on the bracket and
push downward as shown
until a click is heard.
IP Address
Default Gateway