Network - Visonic PowerLink2 User Manual

The Management tab includes the following:
PowerLink2 ID – Allows you to connect to the PowerLink2 with the ID instead
•
of serial number.
Ports - Allows changing the network ports in which PowerLink2 operates.
•
HTTP is the port used for accessing your PowerLink2 from the internal
network. HTTPS is used for access from the internet. If PowerLink2 is
connected to a router that supports UPNP, checking the Open using UPNP will
open the ports on the router automatically.
Session Timeout – The amount of minutes until the user will be auto logged out
•
from the web interface. Setting this to 0 (zero) will disable auto logout.
Factory Settings – Press the RESET button to restore the PowerLink2 to it's
•
factory defaults

Network

The Network tab includes the following:
Hostname – The hostname that PowerLink2 will report to the network
•
IP Address – The network parameters of the PowerLink2:
•
IP Address – The IP address of the Visonic PowerLink2
•
Subnet Mask – The subnet mask used with the IP Address
•
Default Gateway – The default gateway of the network
•
DNS Server – The IP address of the DNS server
•
Managing System Configuration
48