Table of Contents
Advertisement
Step 4.
Close the panel and secure with 2 screws:
Software Installation
The Visonic PowerLink2 software installation procedure involves the following
stages:
· Control Panel Configuration
· Router Configuration
· Visonic PowerLink2 Configuration
Control Panel Configuration
The PowerLink2 is integrated with the PowerMax control panel. This facilitates in the
setup of the required menus that are familiar to the installer.
For detailed programming instructions of the menus, the installer should refer to the
PowerMax Installer Guide, section 4.5 "Defining Communication Parameters".
Setting the Communication Channel
Follow the instructions below to enable DHCP or to set the PowerLink2 IP address.
1. From the PowerMax control panel, enter "INSTALLER MODE" menu using the
Installer Code.
2. Enter the "5.DEFINE COMM." menu.
3. Enter the "2:GPRS / BB" sub-menu.
4. Enter the "LAN SETTINGS" menu.
5. Select "Manual IP or "DHCP Client" and set either one.
Note
If "LAN SETTINGS" does not appear or if it is not possible to enter the menu, check to
make sure that the PowerLink2 has been correctly installed.
Installing the Visonic PowerLink2
12
Hide quick links:
Advertisement
Table of Contents
