Table 5-1. Troubleshooting: Readiness Check - NEC Express5800/320Ma User Manual

General Problems and Solutions
General Problems and Solutions
Table 5-1 describes some common problems that could prevent your system from
passing the readiness check.
!

Table 5-1. Troubleshooting: Readiness Check

Error
IO board nn is
unsafe to pull
RDR disk is not
duplexed
Embedded NIC not
teamed
5-6 Express5800/320Ma: Active Upgrade™ User's Guide
C A U T I O N
Never perform hardware maintenance, such as removing
and replacing system components, while the Active
Upgrade process is running. If you experience a problem
that prevents the Active Upgrade process from completing
successfully, you should always be able to abort the
upgrade session to restore your system to its original
state. If you cannot abort an upgrade session, contact
NEC Technical Support or your authorized support
representative for assistance.
N O T E
For the latest troubleshooting information, including any
issues that were discovered post release, see the
Express5800/320Ma: Active Upgrade User's Guide
online at http://support.necsam.com/servers/.
Action
Verify that all critical system resources (including disks,
Ethernet PCI adapters, and VTMs) are configured correctly
and duplexed. See
more information.
If you recently ran an upgrade session, wait for the RDR
resynchronization process to complete before running
another upgrade session. See
Resynchronizing" on page 5-5
Use the PROset utility to configure your Ethernet PCI
adapters into teams. All embedded Ethernet PCI adapters
must be teamed. See
and "Recommendations" on page 2-5
about configuring Ethernet PCI adapters.
"System Prerequisites" on page 2-2
"Verifying If RDR Disks Are
for more information.
"System Prerequisites" on page 2-2
for more information
for