Table of Contents
Advertisement
Installing
Install SFP transceivers
The switch has been validated with transceivers that support a variety of interconnection
media. To install a transceiver, insert the transceiver into the port and gently push in on the
SFP until the it snaps in place. To remove a transceiver, gently press the transceiver into the
port to release the tension, and then pull out on the release tab to remove the transceiver from
the chassis.
Note:
pressure, pull it out of the port, turn it over, and re-insert it.
Figure 13: Installing an SFP transceiver
34
The transceiver fits only one way in the port. If the transceiver does not install under gentle
HP StorageWorks 2/8q Fibre Channel Switch Installation Guide
Advertisement
Table of Contents
