Network Connection Setting - Toshiba BDX2250KC Owner's Manual

Customizing the Function Settings

Network Connection Setting

1. Press / to select Network in stop mode, then press
button,
I. If no Ethernet cable is connected to the ETHERNET
jack on the back of your player, a screen similar to the
following appears:
Wireless
Network List
WiFi Protected Setup (WPS)
Manual
IP Settings
For detailed operations, refer to the "Confi guring a
wireless Internet connection".
II. If a wired connection is made to your player, a screen
similar to the following appears:
Wired IP Settings
Link Status Link up
MAC Address 00:23:18:75:b1:2b
Dynamic
IP Mode
IP Address 128.60.3.31
Subnet Mask 255.255.0.0
Gateway 128.60.1.1
Primary DNS 128.60.1.41
Secondary DNS 128.60.1.42
Apply
Cancel Network Test
Refer to the "Confi guring a wired Internet connection"
for details.
Note: "Wireless" and "Wired" are optional and do not appear
at the same time. Normally, "Wireless" is shown without
wired connection. While using a wired Internet connection,
"Wireless" is disabled and "Wired" is activated.
Confi guring a wired Internet connection
1. Press / to select Network in stop mode, then press
button to enter the following screen:
If the network connection is active, Link Up appears next
to Link Status. If the network connection is not active,
Link Down displays next to Link Status.
2. Press / to select IP Mode, then press OK.
3. Press / to select an IP mode. You can select:
• Manual — Lets you manually confi gure network
settings, such as IP address, subnet mask, and
gateway settings.
• Dynamic — Uses DHCP to automatically obtain an
IP address.
26
4. Press / / / to highlight Network Test, and
press OK to test your network connection.
5. Press or RETURN to go to the previous menu.
Confi guring a wireless Internet connection
This section describes how to confi gure the Blu-ray Disc™
player for accessing the internet via a WiFi connection. The
procedure for connecting to a wireless network depends
on various network parameters. Read the following
confi guration methods to determine which instructions to
use to connect to your network.
I. Connection to the wireless Network which you
select
a. Connecting to an Unencrypted Wireless Network
b. Connecting to an Encrypted Wireless Network
II. Connection to the wireless Network using Wi-Fi
Protected Setup (WPS)
a. Connecting to a Wireless Network Using WPS
Pushbutton
b. Connecting to a Wireless Network Using WPS PIN
III. Connection to the wireless Network using Manual
IP Confi guration
Description of the Wireless Network List Display
Choosing "Network List" in the wireless network setup
menu will cause a list of available WiFi networks to appear,
as shown below:
Network List
WiFi a
WiFi b g n
a
WiFi
b g
WiFi
WiFi b g
WiFi-me*
Panda
dlink_media
NTGR 11g
Airport_SN