Network Connection Setting - Toshiba BDX3000KU Owner's Manual

stomizing the Function Settings
[ Network Connection Setting
1. Press T / ... to select Network in stop mode, then press
~ button,
I.
If no Ethernet cable is connected to the ETHERNET
jack on the back of your player, a screen similar to the
following appears:
Wireless
I
Network List
WiFi Protected Setup (WPS)
Manual
IP Settings
For detailed operations, refer to the "Configuring a
wireless Internet connection".
II. If a wired connection is made to your player, a screen
similar to the following appears:
Wired IP settings
link
Status ~ Link up
MAC Address OO:23:18:75:bl :2b
I
IP Mode ~ Dynamic
I
iP Address
128.503.31
Subnet Mask 255.255.0.0
Gateway 128.6011
Primary DNS 128601.41
Secondary DNS 128.60.1.42
Apply
I
Cancel
I
Network Test
I
Refer to the "Configuring a wired Internet connection"
for details.
Notes:
• "Wireless" and "Wired" are optional and do not appear
at the same time. Normally, "Wireless" is shown without
wired connection. While using a wired Internet connection,
"Wireless" is disabled and "Wired" is activated.
1. Press T / ... to select Network in stop mode, then press
~
button to enter the following screen:
If the network connection is active, Link Up appears next
to Link Status. If the network connection is not active,
Link Down displays next to Link Status.
2. Press T / ... to select IP Mode, then press OK.
Wired IP settings
link Status ~ Link up
MAC Address 00:23:18:75:b1 :2b
IP Mode ~ Dynamic
iP Address 128.60.3.31
Subnet Mask
255.2550.0
Gateway 128.60.1.1
Primary DNS 128.60.1.41
Sewndary DNS 128.60.1.42
Apply
I
Cancel
I
Network Test
I
3. Press T / ... to select an IP mode. You can select:
• Off - Disables the network interface.
• Manual - Lets you manually configure network settings,
such as IP address, subnet mask, and gateway settings.
• Dynamic - Uses DHCP to automatically obtain an IP
address.
4. Press T / ... /
~
/ .... to highlight NetworkTest, and press
OK to test your network connection.
5. Press ... or RETURN to go to the previous menu.
This section describes how to configure the SD player for
accessing the internet via a WiFi connection. The procedure
for connecting to a wireless network depends on various
network parameters. Read the following configuration
methods to determine which instructions to use to connect
to your network.
I.
Connection to the wireless Network which you
select
a. Connecting to an Unencrypted Wireless Network
b. Connecting to an Encrypted Wireless Network
II. Connection to the wireless Network using Wi-Fi
Protected Setup (WPS)
a. Connecting to a Wireless Network Using WPS Pushbutton
b. Connecting to a Wireless Network Using WPS PIN
III.Connection to the wireless Network using Manual
IP Configration
Description of the Wireless Network List Display
Choosing "Network List" in the wireless network setup
menu will cause a list of available WiFi networks to appear,
as shown below:
Network List
II)
WiFI!I1
Ilil "
I II
WiFi-me·
II)
WIFi'
~Gl
II!!"
Panda
WIFI
" N T G R 11g
1
36
WIFI
I: •
Al""",--SN