Connecting A Usb Fl Ash Drive - Toshiba BDX2250KC Owner's Manual

Connections
Connecting your player to a wireless access point or router
Your Blu-ray Disc™ player has an integrated Wi-Fi device and antenna. No physical connection to the wireless router
is necessary.
• Confi gure your player to access the wireless access point or router. For more information, see "Confi guring a wireless
Internet connection" on page 26.
• The network confi guration and connection method may vary depending on the equipment in use and the network
environment. Your Blu-ray Disc™ player is equipped with an IEEE 802.11n wireless module, which also supports the
802.11 a/b/g/n standards. For the best wireless performance, we recommend using an IEEE 802.11n certifi ed Wi-Fi
network (access point or wireless router).
Wireless access point
Modem Port
Modem Cable
Connecting a USB Flash Drive
A USB fl ash drive provides an additional memory to
software upgrade and enjoy BD-Live™ bonus content.
You can also enjoy playing back MP3/WMA/JPEG/MKV
fi les stored in the USB fl ash drive.
Inserting a USB fl ash drive into the USB port on the back
of Blu-ray Disc™ player until it clicks.
Notes:
• Connect only a USB fl ash drive to the USB port on this product.
• If you cannot easily insert the USB fl ash drive, you may have
inserted it incorrectly. Try to turnover the device and then insert
again.
• Do not remove the USB fl ash drive during playback.
• BD-Live™: Access to BD-Live™ requires use of USB fl ash drive
(not included) installed in the USB port. For additional information
regarding the access to BD-Live™, see page 21 of the manual.
• TOSHIBA does not guarantee 100% compatibility with all USB
fl ash drives.
12
Notes:
• You must use a wireless IP sharer that supports
IEEE 802.11 a/b/g/n. (n is recommended for
stable operation of the wireless network.)
• Wireless LAN, in its nature, may cause
interference, depending on the use condition
(AP performance, distance, obstacle, interference
by other radio devices, etc.).
• Set the wireless IP sharer to Infrastructure mode.
Ad-hoc mode is not supported.
• When applying the security key for the AP
(wireless IP sharer), only the following is
supported.
1) Authentication Mode : WPAPSK, WPA2PSK
2) Encryption Type : WEP, TKIP, AES
USB
USB Flash Drive