Table of Contents
Advertisement
Function setUp
stomizing the Function Settings
You can change the default settings to customize performance to your preference.
General Operations
IP
Settings
Un Slat
~
n 0
1. Press
T /
A to select Settings in home menu while in full
stop mode, the Settings menu appears.
2.
Press
~
button, then use
A / T
button to select the setting
options.
3. Press OK button.
4. Press
~
or RETURN button to return to the previous
menu.
IP Mode
~
Dynamic
IP Addr ss
0000
Subnet
k
COOO
Gate ay
0000
Prim ryO S
0000
Seco daryO S
0000
Network List
WiFIC
III
WiFI-me'
]
WiFl, •
'I
Panda
WiFIC
II
dlmlunedie
WiFI· ,
"
NTGR11g
WiFi· •
Aitl><>rt...SN
2. Press
T /
A to select IP Mode, then press OK.
3. Press
T / A
to select an IP mode. You can select:
• Off - Disables the network interface.
• Manual -
Lets you manually configure network
settings, such as IP address, subnet mask, and
gateway settings.
• Dynamic - Uses DHCP to automatically obtain an I P
address.
4. Press .... or RETURN to go to the previous menu.
Configuring a wireless Internet connection
This section describes how to configure the
SO
player for
accessing the internet via a WiFi connection. The procedure
for connecting to a wireless network depends on various
network parameters. Read the following configuration
methods to determine which instructions to use to connect
to your network.
I. Connection to the wireless Network which you
select
a. Connecting to an Unencrypted Wireless Network
b. Connecting to an Encrypted Wireless Network
II. Connection to the wireless Network using Wi-Fi
protected Setup(WPS)
a. Connecting to a Wireless Network Using WPS Pushbutton
b. Connecting to a Wireless Network Using WPS PIN
III.Connection to the wireless Network using Manual
IP Configration
Description of the Wireless Network List Display
Choosing "Network List" in the wireless network setup menu
will cause a list of available WiFi networks to appear, as
shown below:
Network Test
Settings menu items
submenu display area
Configuring a wired Internet connection
Wireless
1.
Press
T / A
to select Network in stop mode, the network
connection menu appears.
2. Press
~
button, then use A / T button to select the desired
connection setting.
3. Press OK button.
1. Press T / A to select Wired, then press OK to confirm.
The IP Settings screen appears.
If the network connection is active, Link Up appears next
to Link Status. If the network connection is not active,
Link Down displays next to Link Status.
[ Network Connection Setting
1
28
Advertisement
Table of Contents
