Toshiba Strata CIX40 R5.2 Software - R1 ~ R3 Hardware Installation And Maintenance Manual page 68

CIX40 Default Database
CIX40 Default Initialized Data
Table 2-8 Program 100 Default Data — GMAU2 -- R1 HW System with R5.1 SW
Equip.
Nos.
0101 8 - Digital Telephones (no speaker OCA)
0102 3 - CO lines with CLID
0103 Not used
0104 Standard Telephone 01~02
0105 4 - Voice Mail ports
4 - CO lines with CLID
0106
8 - Channel IP Interface
0107 8 - Digital Telephones
0108 3 - CO Lines with CLID
0205 Virtual BIOU
*Slot codes are set during system initialization and cannot be changed.
1.The GMAU2, GVPH1 and GSTU1 PCB Slot Codes and the Station/CO Line numbers are set
during initialization even if the cards are not installed in the cabinet. The GCDU2 must be
installed in the cabinet before initialization for auto recognition of slot code, station numbers and
CO line numbers.
2.The ports must be assigned, after the card is installed. The GIPU8, GIPH and MIPU are the
only CIX40 cards that require licensing. Use eManager to install Strata Net, End point and
SoftIPT licenses and, assign PDNs and Strata Net channels.
3.The CHSU40A (R1) cabinet supports GIPU8, GIPH and MIPU16 only, not the MIPU24.
4.When the GCDU2 is installed after the CIX40 is initialized use eManager to assign the slot
code, station numbers and CO line numbers.
5.CO8 to CO10 if the GCOCIH card is installed.
2-4
Circuits
Table 2-9 Prog 921 Traffic Measurement Control (R5.10 SW)
FB1 Traffic Measure Activate
FB14 Traffic Measure ILG
FB15 Traffic Measure OLG
PCB
Station / Line
1
Numbers
Code
017 200~207
028 CO1~CO3
01~208
026
02~217
035
220~223
032 CO4 ~ CO7
036 ~ 038 Not assigned
017 209~216
CO4~CO6 or
028
CO8~CO10
Relay Contact
020
Page, MOH
Enable
ILG1 Enable
OLG1 Enable
Strata CIX40 R3 Installation & Maintenance
Connection
GMAU2
(motherboard)
01-GMAU2
02-GSTU1
GVPH1
GCOCIH
GIPU8/GIPH/
2
3
MIPU
4
GCDU2
5
GCTU2
05/10