Toshiba Strata CIX40 R5.2 Software - R1 ~ R3 Hardware Installation And Maintenance Manual page 24

CIX40 Installation
Installing the CIX40 Cabinet
Step 1: Install Power Wiring
Important!
1. Refer to
remove the clamp. Plug in the 25-pair Amphenol connector and replace the clamp to hold the
Amphenol connector in place.
2. Connect all other PCB wiring (e.g., modular CO line cords, LAN cable, etc.). Slide the shorter
tie-wrap through the holder. Then fasten wiring to the unit with the tie wrap that comes with the
cabinet.
3. Connect the end of the AC adapter cable to the GMAS PCB as shown in
4. Connect the other end of the GCTU2 (100Base TX) LAN cable to the LAN connected to a LAN
switch or the eManager PC.
5. Plug the AC adapter into a power outlet.
6. Put the On/Standby switch on the GMAU into the "On" position. The DC LED should light
green. The CIX40 is now ready to program.
WARNING! Do not smoke near batteries. Avoid creating any electrical sparks near
CAUTION! On CHSU40A/CHSU40A2 systems: Do not wrap the power cord around the AC
Figure 1-9 AC Adapter Wiring Procedure
1-14
Ensure that you have the correct power adapter for the cabinet being installed.
R1 and R2 HW (GMAU2/3) use factory-shipped AC adapter SQ60W15P-00
R3 HW (GMAU4) use factory-shipped AC adapter ACADP40-1A
Figure 1-9 for the following steps. Loosen the screw on the Amphenol clamp and
batteries.
adaptor. Excess cord should be gathered and secured with the supplied strap.
The cord bundle may be secured to the side of the adapter.
1
3
Strata CIX40 R3 Installation & Maintenance
Figures 1-9 and 1-4.
2
4
7257
05/10