Toshiba Strata CIX40 R5.2 Software - R1 ~ R3 Hardware Installation And Maintenance Manual page 23

3. Place the cabinet base on the desired
location on the mounting surface and
mark the location of the four screw
holes. See Figures 1-7
4. Using a hard board between the
cabinet and the wall, secure the hard
board to the wall first, making certain
that screws are aligned with studs. See
Figure 1-8.
5. Drill holes on these marks and secure
screws approximately two thirds of the
way into the top two holes on the
mounting surface.
6. Hang the unit from the top two screws
and then secure the top screws
completely into the mounting surface.
7. Finish securing the unit to the mounting
surface by completely screwing the
bottom two screws into the wall.
Note Check local building and electrical
codes concerning the hard board or
plywood mounting board requirements.
Figure 1-8 CIX40 Cabinet Wall Mounting
8. Ground system according to
Strata CIX40 R3 Installation & Maintenance
and 1-8.
Plaster
Stud
Board
Base KSU
"AC Power and Grounding Requirements" on page
05/10
Mark screw
locations.
Figure 1-7 CIX40 Interior
Method 2
Hard Board
(1/2 Inch Plywood)
7114
CIX40 Installation
Installing the CIX40 Cabinet
7104
1-10.
1-13