Toshiba Strata CIX40 R5.2 Software - R1 ~ R3 Hardware Installation And Maintenance Manual page 46

CIX40 Installation
Detailed PCB Installation
Install the MIPU 16 or 24-Channel IP Interface PCB
(optional)
When the GIPH1, GIPU8, or an MIPU card is installed, a GCOCIH1 (four circuit CO Line interface)
cannot be installed.
1. Turn off system power.
2. In the CIX40 cabinet, remove the two screws and the PCB stopper
3. If the GCTU2 is installed remove it.
4. If the MIPU is setup for CIX100,
200, 670 cabinets (as shown here)
it must be configured for
installation in a CIX40 cabinet.
Remove the mounting plate and
mounting rail.
5. Install the Pull Tab and plastic
spacers included in the MIPU package.
Pull tab
Plastic spacer
1-36
Plastic spacer
(Figure
Mounting Plate
Mounting Rail
Strata CIX40 R3 Installation & Maintenance
1-21).
05/10