Loading A Cd; Ejecting A Cd - Tascam DP-32 Digital Portastudio Owner's Manual

CAUTION
• Pull the tray out completely. If you try to load a disc
into the tray or remove a disc from it when it is not
open completely, the disc could be scratched, making
it unusable.
• Do not touch the writable (unlabeled) side of a disc.
Doing so could cause it to become dirty or scratched,
making it unusable.

Loading a CD

1. As shown in the illustration, hold the edge of the
disc with the label side up and put it into the tray
so that its central hole is on the round protrusion at
the center of the tray.
2. Press the disc gently near the center to set it on the
tray.
The disc should click into place and be level with the
tray.
3. Push the tray to close it. The tray will click when
shut.
ª When a disc is not properly loaded
Pull the tray out completely once, reload the disc properly
and push the tray closed again. (If you force the disc in,
the unit or the disc could be damaged.)

Ejecting a CD

1. When in
Multi Track
to open the menu.
CD
2. Press the F3 (-) button or the disc tray eject
button on the front panel to open the tray slightly,
and then pull the tray out until it opens completely.
Hold the disc by its edges and lift it out.
CAUTION
Do not lift the disc forcibly. Doing so could damage the
unit or the disc.
14 - Using CDs
mode, press the CD button
81
TASCAM DP-32