Mounting The Serverboard Into A Chassis; Installing Memory - Supermicro Supero H8DAR-i User Manual

H8DA8/H8DAE/H8DAR-8/H8DAR-i User's Manual
2-3

Mounting the Serverboard into a Chassis

All serverboards and motherboards have standard mounting holes to fi t different
types of chassis. Make sure that the locations of all the mounting holes for both
the serverboard and the chassis match. Although a chassis may have both plastic
and metal mounting fasteners, metal ones are highly recommended because they
ground the serverboard to the chassis. Make sure that the metal standoffs click in
or are screwed in tightly.
1. Check the compatibility of the serverboard ports and the I/O shield
The H8DA8/H8DAE/H8DAR-8/H8DAR-i serverboard requires a chassis that can
support extended ATX boards of 12" x 13.05" in size. Make sure that the I/O ports
on the serverboard align with their respective holes in the I/O shield at the rear of
the chassis.
2. Mounting the serverboard onto the mainboard tray in the chassis
Carefully mount the serverboard onto the mainboard tray by aligning the serverboard
mounting holes with the raised metal standoffs in the tray. Insert screws into all
the mounting holes in the serverboard that line up with the standoffs. Then use a
screwdriver to secure the serverboard to the mainboard tray - tighten until just snug
(if too tight you might strip the threads). Metal screws provide an electrical contact
to the serverboard ground to provide a continuous ground for the system.
2-4

Installing Memory

Exercise extreme care when installing or removing memory modules
1. Insert each memory module vertically into its slot, paying attention to the notch
along the bottom of the module to prevent inserting the module incorrectly (see
Figure 2-2). See support information below.
2. Gently press down on the memory module until it snaps into place.
Note: each processor has its own built-in memory controller, so CPU2 DIMMs can-
not be addressed if only a single CPU is installed. 128 MB, 256 MB, 512 MB, 1
GB, 2 GB* and 4 GB* memory modules are supported.
CAUTION
to prevent any possible damage.
2-4