Table of Contents
Advertisement
Item
Name
Secondary DNS
7
Server IP
Address
Remote
8
Console &
HTTPS Port
9
HTTP Port
10
SSH Port
11
Bandwidth Limit
Enable SSH
12
Access
Disable Setup
13
Protocol
LAN Interface
14
Speed
LAN Interface
15
Duplex Mode
16
Apply
Reset to
17
Defaults
Table 7-1. Network Page Controls (Continued)
Description
Enter the IP address of the Secondary Domain Name Server in the box. It
will be used when the Primary DNS Server cannot be contacted.
Enter the port numbers the remote host and the HTTP server are listening.
If a number is not entered in the box, the default value will be used.
Enter the port number the of the HTTP server. If a number is not entered in
the box, the default value will be used.
Enter the port number of the SSH server. If a number is not entered in the
box, the default value will be used.
Enter the maximum bandwidth value for network interfacing. The value
should be in Kbits per second.
Click this box to enable SSH access.
Check this box to disable the setup protocol function of the SIMBL card.
Click on the arrow on the right to select a desired LAN interface speed from
the pull-down menu. The options are Auto-detect, 10 Mbps or 100 Mbps. If
Auto-detect is selected, the optimized speed will be set based on the
system configurations detected by the OS.
Click on the arrow on the right to select a desired LAN interface duplex
mode from the pull-down menu. The options are A
D
and F
UPLEX
ULL
D
M
will be set to the optimized setting based on the system
UPLEX
ODE
configurations detected by the OS.
Click this icon to apply the selections you made.
Click this icon if you want to reset the defaults for the Remote Console
button keys.
D
. If Auto-detect is selected, the LAN I
UPLEX
7-3
Chapter 7: Device Settings
-
, H
UTO
DETECT
NTERFACE
ALF
Advertisement
Table of Contents
