Table of Contents
Advertisement
Item
Name
Gigabit Switch
1
Status
10Gb
2
Pass-Through
Status
10Gb Switch
3
Status
4
Power On
5
Power Off
6
HW Reset
Refresh Gigabit
7
Switch Status
NOTE: Initially, you must manually enter the IP address for each GbE switch to
gain access to it. Each IP address should be unique when there are multiple
GbE switches on the same network segment.
After gaining access to the GbE switch(es), you can use the reset button to reset their
configurations to the default settings. The reset button will reset all GbE switch
configurations, including IP address and so on.
Table 2-3. Gibabit Switch Status Page Controls
Description
Click on a switch listed in this section to manage and configure that GbE
switch.
Click on a switch listed in this section to manage and configure that 10Gb
pass-through switch.
Click on a switch listed in this section to manage and configure that 10Gb
switch.
Click this icon in each section to power up a selected GbE module.
Click this icon in each section to shut down a selected GbE module.
Click this icon in each section to reset a GbE module to its default settings.
Click this icon to refresh the page and update the status of a switch shown.
2-5
Chapter 2: Blade System
Advertisement
Table of Contents
