Table of Contents
Advertisement
config
system interface
Use this command to change the IP address and management access setting of the
FortiSwitch-5003A mgmt (management) interface and to bring the mgmt interface up or down.
Syntax
config system interface
set
set
set
end
Variables
status {down | up}
ip <interface_ipv4mask> Enter the mgmt interface IP address and netmask.
allowaccess
<access_types>
Example
This example shows how to set the mgmt interface IP address and netmask and to configure the mgmt
interface to allow ping, ssh, and telnet administrative access.
config system interface
set ip 172.20.120.178/24
set allowaccess ping ssh telnet
end
Related topics
•
config route static
104
status {down | up}
ip <interface_ipv4mask>
allowaccess <access_types>
Description
Bring the mgmt interface up or down (start or stop the
interface). If the interface is down, it does not accept or send
packets.
Enter the types of management access permitted on the mgmt
interface. Valid types are: ping ssh telnet. Separate each
type with a space.
To add or remove an option from the list, retype the complete
list as required.
FortiSwitch-5003A and 5003 Fabric and Base Backplane Communications Guide
FortiSwitch-5003A CLI reference
Default
up
192.168.1.99
255.255.255.0
01-30000-85717-20081205
Advertisement
Table of Contents
