Table of Contents
Advertisement
Fabric 10-gigabit switching within a chassis
32
Figure 13: Example 10-gigabit connection between internal and external networks
Internal Network
Internal 10-gigabit
network connected to
fabric channel 2
13
FortiGate-RTM-XB2
modules installed
in RTM slots 9, 11,
and 13 provide two
10-gigabit fabric
channels and NP2
acceleration
for each
FortiGate-5001A
board
External 10-gigabit
network connected
to fabric channel 1
External
Network
Note: On some versions of the FortiGate-5001A firmware, when a FortiGate-5001A board
starts up with a FortiGate-RTM-XB2 module installed, the fabric1 and fabric2 interfaces are
replaced with interfaces that are named RTM/1 and RTM/2 to indicate the presence of the
FortiGate-RTM-XB2 module. Configuration settings that include the fabric1 and fabric2
interface names will have to be changed to use the RTM/1 and RTM/2 interface names.
If the data traffic contains VLAN-tagged packets, you must add the VLAN tags to
the FortiSwitch-5003A interfaces that will handle the VLAN-tagged traffic. For
example, to allow VLAN tags 300 to 305 on slots 9, 11, and 13 and the F7 front
panel interface, from the FortiSwitch-5003A CLI enter:
config switch fabric-channel interface
edit "slot-9"
set allowed-vlans 1,300-305
next
edit "slot-11"
set allowed-vlans 1,300-305
next
edit "slot-13"
set allowed-vlans 1,300-305
next
edit "f7"
set allowed-vlans 1,300-305
end
FortiSwitch-5003A and 5003 Fabric and Base Backplane Communications Guide
FortiGate-5140 fabric backplane communication
Fabric channel 2
10-gigabit data
communication
5140SAP
SERIAL 1
5140
11
9
7
5
3
1
2
4
6
8
FILTER
0
FAN TRAY
1
FAN TRAY
2
Fabric channel 1
10-gigabit data
communication
FortiGate-RTM-XB2
modules installed
in RTM slots 6, 8,
and 10 provide
two 10-gigabit fabric
channels and NP2
acceleration for each
SERIAL 2
ALARM
FortiGate-5001A board
10
12
14
ETH0 ETH1
ETH0
Service
RESET
STATUS
Hot Swap
1 2
ETH0 ETH1
ETH0
Service
RESET
STATUS
Hot Swap
FAN TRAY
01-30000-85717-20081205
Advertisement
Table of Contents
