Result Codes; Terminology And Acronyms; Current Firmware Versions - Sierra Wireless UMTS Command Reference Manual

Supported AT Command Reference
Note: Revision codes that
include letters, such as 2.1A, are
to be considered drafts and are
subject to change before final
release.
8

Result codes

Result codes are not shown in the command tables unless
special conditions apply. Generally the result code
returned when the command has been executed.
be returned if parameters are out of range, and will be
returned if the command is not recognized or is not permitted
in the current state or condition of the modem.

Terminology and acronyms

This document makes use of acronyms that are in common use
in data communications and cellular technology. Our Internet
site provides a Glossary of Terms and Acronyms (document
number 2130891) that may be helpful in understanding some
acronyms and terminology used in this guide.

Current firmware versions

Versions
This document is revised periodically as new
Document
firmware versions are released. This edition is:
Rev 2.4 Jan.08
Applicability of commands to different modules
command listed in this guide includes a list of supporting
AC8xx and MC87xx modules. Unless otherwise noted, the
following minimum firmware revisions are required to
support the listed commands:
• AC850 / AC860 / MC8755 / MC8765 – Revision U1_2_0 or
higher
• AC875 / MC8775 / MC8775V – Revision H1_0_0_0 or
higher
• AC880 / MC8780 / MC8781 – Revision D1_0_3_0ap /
F1_0_0_0ap or higher
To determine your firmware revision:
• Enter the identification command
The modem responds with version information for
software, firmware, and hardware.
The details following the revision number include Sierra
Wireless information on the specific build followed by the
date and time of the build.
+GMR: ... F/W VER: R1_0_0_...
OK
is
ERROR
may
Each
AT+GMR
2130617