Verify The M1306B Network Registration; Table 7: Values Of Network Registration - Wavecom FASTRACK M1306B User Manual

5.7 Verify the M1306B Network Registration

1. Make sure a valid SIM card has been previously inserted in the M1306B SIM
card holder.
2. Using a communication software such as a Hyperterminal, enter the following
AT commands:
a.
AT+CPIN=xxxx
b.
AT+CREG?.
The format of the returned response is as follows:
+CREG: <mode>,<stat>
• <mode>
• <stat>
3. Verify the state of registration according the returned value given in the table
below.
Returned Value (*)
<mode>,<stat>
+CREG: 0,0
+CREG: 0,1
+CREG: 0,5
(*)For further information on the other returned values and their meaning, refer to "AT
Commands Interface Guide" [7].
If the M1306B is not registered, perform the following procedure:
•
Check the connection between the M1306B and the antenna.
•
Verify the signal strength to determine the received signal strength (refer to
section 5.5).
Note: For information on AT command relating to the network registration in GPRS
mode, and in particular: CGREG, CGCLASS, CGATT, refer to "AT Commands Interface
Guide" [7].
confidential ©
This document is the sole and exclusive property of WAVECOM. Not to be distributed or divulged
without prior written agreement.
WM_PRJ_M13_UGD_001 -003
to enter PIN code xxxx.
To ascertain the registration status.
with:
= unsolicited registration message configuration,
= registration state.

Table 7: Values of network registration

No (not registered)
Yes (registered, home network)
Yes (registered, roaming)
Fastrack M1306B User Guide
Using the M1306B Wireless CPU
Network registration
®
Page: 34 / 65
November 11, 2006