Conformity; Protections; Power Supply; Overvoltage - Wavecom FASTRACK M1306B User Manual

Lubrication of the SIM card had been tested by Wavecom (using Tutela Fluid 43EM
from MOLYDUVAL) and gives very good results.
If waterproof enclosure with a desiccant solution is used, check with your desiccant
retailer the quantity that must be used according to the enclosure dimensions. Ensure
humidity has been removed before sealing the enclosure.
Any solution selected must be qualified by the customer on the final application.
To minimize oxidation problem on the SIM card, its manipulation must be done with
the greatest precautions. In particular, the metallic contacts of the card must never be
touched with bare fingers or any matter which may contain polluted materials liable
to produce oxidation (such as, e.g. substances including chlorine). In case a cleaning
of the Card is necessary, a dry cloth must be used (never use any chemical
substance).

8.4 Conformity

The complete product complies with the essential requirements of article 3 of R&TTE
1999/5/EC Directive and satisfied the following standards:
Safety standard
Efficient use of the radio
frequency spectrum
EMC
Global Certification Forum –
Certification Criteria

8.5 Protections

8.5.1 Power Supply

The M1306B is protected by a 800 mA / 250 V fuse directly bonded on the power
supply cable.
The model of fuse used is: FSD 800 mA / 250 V FAST-ACTING.

8.5.2 Overvoltage

The M1306B is protected against voltage over +32 V.
When input voltages exceed +32 V, the supply voltage is disconnected in order to
protect the internal electronic components from an overvoltage.
confidential ©
This document is the sole and exclusive property of WAVECOM. Not to be distributed or divulged
without prior written agreement.
WM_PRJ_M13_UGD_001 -003
Domain
Fastrack M1306B User Guide
Technical Characteristics
Applicable standard
EN 60950 (ed.1999)
EN 301 419-(v 4.1.1)
EN 301 511 (V 7.0.1)
EN 301 489–1 (edition 2002)
EN 301 489-7 (edition 2002)
GCF-CC V3.13.0
Page: 59 / 65
November 11, 2006