Echo Function Disabled; Table 4: M1306B Operational Status - Wavecom FASTRACK M1306B User Manual

LED Status LED light activity
ON LED ON permanent
LED Flashing slowly
LED Flashing rapidly
OFF LED OFF

5.4 Echo Function Disabled

If no echo is displayed when entering an AT command, that means:
•
The "local echo" parameter of your communication software (such as
Hyperterminal) is disabled.
•
The M1306B echo function is disabled.
To enable the M1306B echo function, enter the
When sending AT commands to the M1306B by using a communication software, it
is recommended:
•
to disable the "local echo" parameter of your communication software (such as
Hyperterminal),
•
to enable the M1306B echo function (
In a Machine To Machine communication with the M1306B, it is recommended to
disable the M1306B echo function (
processing.
For further information on
Interface Guide" [7].
confidential ©
This document is the sole and exclusive property of WAVECOM. Not to be distributed or divulged
without prior written agreement.
WM_PRJ_M13_UGD_001 -003

Table 4: M1306B operational status

M1306B is switched ON but
not registered on the network
M1306B
registered on the network, but no
communication is in progress (Idle
mode)
M1306B
registered on the network, and a
communication is in progress
M1306B is switched OFF.
ATE1
command) in order to avoid useless CPU
ATE0
and
ATE0 ATE1
Fastrack M1306B User Guide
Using the M1306B Wireless CPU
M1306B status
is switched
is switched
.
ATE1
command).
commands, refer to "AT Commands
®
ON and
ON and
Page: 32 / 65
November 11, 2006