Programming Terminal Without Software; Introduction - Acroprint Time and Attendance System Manual

12. Programming terminal without software

12.1 Introduction

The Time Clock terminal is primarily self-prompting to
supervisors. The Main Menu is activated by swiping a
Supervisor Badge. The headings for each group on the next
four pages are the choices which appear in the Main Menu.
The menu key (either up or down) is used to reach the menu
subject desired. Pressing ENTER opens the specific task
menu. The following Supervisor's Menu Map shows menus
and choices available.
All branches in the menu can be reached by simply using the
ARROW and ENTER keys. The CLEAR key will move
you to the previous menu.
A prompt for further input may appear after a function has
been selected. The ARROW keys can still be used, but the
Time Clock terminal provides the convenience of a numerical
pad. If prompted for a Badge Number or to select an
employee, the option of swiping the badge may be used.
After a critical function or data has been entered, an
>ENTER TO CONFIRM< prompt is used to protect against
unwanted entries. Typically, the Time C lock terminal will
display the programmed data on the bottom line of the display
as the selections are being scrolled through on the top line.
The data programmed into the Time Clock terminal can be
reviewed in this fashion. If there are any doubts about what
has been programmed, simply print the appropriate report.
HINT: PROGRAM TERMINAL AT PC USING SOFTWARE
AND CABLE SUPPLIED BEFORE USING AS
STAND-ALONE TERMINAL.
Programming the Time C lock terminal manually
34