Loop Applications - Shure PSM700 User Manual

Mono
Use this setup when there is only one output from the mixer.
1. Connect the mixer to either the Left/CH.1 or Right/CH.2 input of the transmitter.
2. Set the SOURCE switch on the transmitter to MONO.
NOTE: The setting of Dip switch 2 on the receiver has no effect in this setup.

LOOP Applications

Use the LOOP OUT L (left) and R (right) outputs to send a copy of the audio signal going into the transmitter to
other devices. Shown here are a few examples of the many applications for the LOOP outputs.
NOTE: The input level control and the input pad do not affect the level of the LOOP signals.
Stereo for Multiple Systems
Use the LOOP OUT connectors to send one stereo signal
from the mixing console to multiple P7T or P6T wireless
transmitters. This frees up sends on the mixing console for other
uses.
Set up each system for stereo control as shown in the Stereo
Control section. Connect the first transmitter to the mixer.
Connect the next transmitter to the first transmitter's LOOP
outputs. Form a chain using all the transmitters in your
installation.
1.
2.
English - 7