Dip Switches - Shure PSM700 User Manual

P7R Receiver
Balance Control. In stereo mode, this controls the left/right balance. In MixMode™, it controls the relative level of the two transmitter
inputs.
Earphone Connector. 3,5 mm (1/8-in.) phone jack connects to the earphones.
Left=tip, right=ring, ground=sleeve.
Low Battery LED (LOW BATT). Illuminates when the battery has approximately 45 minutes of operating time remaining, depending on
the volume.
Power LED (PWR ON). Illuminates when the power is ON and the battery is good.
Power Switch and Volume Control (VOLUME).
Antenna and Connector. Attach the antenna to the antenna connector. Use the red dot to align the threads.
RF Signal LED (RF ON). Illuminates when the P7R is receiving a signal from the transmitter.
Battery Compartment. Accepts one 9-volt battery. Open the door by pressing the latches on both sides and pulling.
DIP Switches. See DIP Switches or the label on the inside cover of the battery door.
Channel Selector. See Selecting Channels.
Reversible Belt Clip. Belt clip can be removed and installed in the reverse position so the antenna points down when the body-pack is
worn.

DIP Switches

1—Channel Group
Group 1
Group 2
2—Balance Control
MixMode
Stereo
IMPORTANT: The limiter responds to unexpected signal peaks. It does not prevent long-term exposure to high SPL
levels. This limiter is optimized for Shure E-Series earphones. The maximum limited SPL may be different for
other earphones. Do not switch the limiter off unless you are using an external limiter.
4
- English
3—Equalization
High Boost (Offers more high-end response: 6 dB boost at
10 kHz)
Normal (Flat)
4—Limiter
On
Off