panja Black/White LCD Instruction Manual page 9

FIG. 3 Decor style (AXD) and BB-MTP cutout dimensions (solid surfaces)
6. Disconnect the AXlink connector from the Central Controller.
7. Remove one or more knockouts to accommodate the wiring as required.
8. Thread the incoming AXlink wiring through the knockouts.
9. Fasten the BB-MTP to the solid surface using the supplied mounting screws.
10. Connect the AXlink wiring to the touch panel. Refer to the Wiring the Mini-Touch
Panels section on page 8 for additional wiring information.
11. Test the connection by reconnecting the AXlink connector to the Central Controller. The panel
beeps power-up. Before continuing, disconnect all connections until panel installation is
complete.
12. Place the Decor-style faceplate onto the bezel. You can also secure the faceplate to the bezel
using the four Phillips flathead security screws.
13. Remove the backing from the adhesive tape strips on the touch panel; press the engraved
overlay onto the faceplate. Once attached to the faceplate, the security screws cannot be
replaced without removing the overlay.
14. Reconnect the AXlink wiring to the Central Controller. The touch panel will beep on power-
up.
Black/White LCD Mini-Touch Panels
Installation
5