Installation; Mounting The Mini-Touch Panels; Decor Style Panels With Low-Profile Back Boxes - panja Black/White LCD Instruction Manual

Installation

Mounting the Mini-Touch Panels

The following paragraphs describe mounting the Decor and rack-mount touch panels. TiltScreen
touch panels can be placed on any flat surface.

Decor style panels with low-profile Back Boxes

The touch panel must always be installed with the release slot located at the bottom.
1. Cut out the surface using the dimensions shown in FIG. 1.
FIG. 1 Decor style and low-profile Back Box output dimensions
2. Carefully insert a flat-blade screwdriver into the release slot on the touch panel's faceplate and
remove the engraved overlay.
3. Place the touch panel into the cutout and mark the screw insert positions, as shown in FIG. 1.
4. Remove the touch panel and drill four #6-32 insert holes. Then, place a threaded insert into
each hole.
5. Disconnect the AXlink connector from the Central Controller.
6. Fasten the low-profile Back Box to the surface using the #6-32 machine screws supplied with
the enclosure.
Black/White LCD Mini-Touch Panels
Installation
3