panja Black/White LCD Instruction Manual page 8

Installation
7. Attach the data and power wiring to the touch panel.
8. Test the connection by reconnecting the AXlink connector to the Central Controller. Before
continuing, disconnect all connections until panel installation is complete.
9. Fasten the touch panel and low-profile Back Box using the #6-32 machine screws supplied
with the enclosure panel.
10. Place the faceplate onto the bezel. You can also secure the faceplate to the bezel using the four
Phillips flathead security screws. Once attached to the faceplate, the security screws cannot be
replaced without removing the overlay.
11. Remove the backing from the adhesive tape strips located on the front of the panel; press the
engraved overlay onto the faceplate.
12. Reconnect the AXlink wiring to the Central Controller. The touch panel beeps when power is
applied.
Installing touch panels and a BB-MTP Back Box (solid surfaces)
FIG. 2 shows an AXD-MLC/PB and BB-MTP UniMount Back Box for solid surfaces.
BB-MTP Unimount
Back Box enclosure
Engraved overlay
FIG. 2 AXD-MLC/PB and BB-MTP for solid surfaces
1. Cut out the surface using the dimensions shown in FIG. 3.
2. Carefully insert a flat-blade screwdriver into the release slot on the touch panel's bezel and
remove the engraved overlay.
3. Lay the touch panel facedown on a soft cloth and remove the screws from the low-profile Back
Box; remove the Back Box and discard.
4. Place the BB-MTP into the cutout and mark the threaded insert positions, as shown in FIG. 3.
5. Remove the BB-MTP and drill holes (A and B) for the panel (FIG. 3). Then, place #6-32
threaded inserts into the four holes marked 'B' in the cutout dimensions illustration.
4
Stud mounting
holes
Knockout
Solid surface mounting flanges
AXD-MLC/PB
faceplate
Black/White LCD Mini-Touch Panels