Ford 2000 Contour Owner's Manual page 8

Engine/Transmission
Item
Configuration
Bore x Stroke
Displacement
Compression ratio
Horsepower (SAE net)
Torque
Redline
Specific output
Valvetrain
Fuel system
Mass air sensor
Throttle body
Port throttles
Exhaust manifolds
Exhaust system
8
Description
Transversely mounted, 60-degree
V6, cast aluminum block and
heads, iron cylinder liners, fully
counterweighted forged
crankshaft, crankshaft windage
tray, lightened flywheel, structural
aluminum-alloy oil pan
82.4 x 79.0 mm (3.24 x 3.11 in)
2 544 cc/155 cid
10.0:1
149 kW (200 hp) @ 6 600 rpm
226 Nm (167 lb/ft @ 5 500 rpm)
6 750 rpm (fuel shut-off at
7 000 rpm)
78.6 hp per liter
Dual overhead chain-driven cams,
roller finger followers with
hydraulic lash adjustment,
ovate-wire valve springs, four
valves per cylinder. The Extrude
Hone process is used on the
primary and secondary ports
Sequential electronic fuel injection,
19 lb/hr injectors, 379 kPa (55 psi)
70 mm (2.76 in) diameter
60 mm (2.36 in) diameter bore
Electronically actuated 32 mm
(1.26 in) diameter bore-open at
3 250 rpm
Steel tube clamshell design
57 mm (2.25 in) diameter with
63.5 mm (2.50 in) polished
stainless steel tips