Alcatel 060320-10, Rev. B Configuration Manual page 133

Configuring BGP
Route Map Options
Configures a BGP weight value to be
assigned to inbound routes when a match
is found.
Configures the value to strip from the
community attribute of the routes
matched by this route map instance
(sequence number).
For example, to add AS path policy aspathfilter and community list policy commfilter to route map
policy mapfilter, enter the following:
-> ip bgp policy route-map mapfilter 1 aspath-list aspathfilter
-> ip bgp policy route-map mapfilter 1 community-list commfilter
Note. Conditions added to a route map policy must have already been created using their respective policy
commands. If you attempt to add non-existent policies to a route map policy, an error message is returned.
Each component of a route map policy must be added using a separate CLI command as shown above.
OmniSwitch AOS Release 7 Advanced Routing Configuration Guide
Command
ip bgp policy route-map weight
ip bgp policy route-map community-strip
March 2011
Routing Policies
page 3-49