Connecting An Onkyo Ri Dock (Remote Interactive Dock); Connecting The Power Cord - Onkyo CR-535 Instruction Manual

Connecting Other Components—Continued

Connecting an Onkyo RI Dock (Remote Interactive Dock)

The following diagram shows how to connect an optional Onkyo RI Dock (Remote Interactive Dock).
Connect the CD receiver's DOCK IN jacks to the RI Dock's AUDIO OUT jacks.
CD receiver's
rear panel
What can you do with
• Connecting an Onkyo RI Dock to the CD receiver with an
receiver's remote controller. In addition, when playback is started on the RI Dock, the CD receiver will automatically
select it as the input source.
• To use , you must connect the Onkyo RI Dock to the CD receiver with an
(RCA). On the RI Dock, set the RI MODE switch to "HDD" or "HDD/DOCK". See the RI Dock's instruction manual
for details.

Connecting the Power Cord

Notes:
• Before connecting the power cord, connect all of your speakers and AV components.
• Turning on the CD receiver may cause a momentary power surge that might interfere with other electrical equipment
on the same circuit. If this is a problem, plug the CD receiver into a different branch circuit.
Plug the power cord into a suitable wall outlet.
The STANDBY indicator lights up.
For European models
To set the clock with the AccuClock function, the CD receiver must be able to receive RDS radio stations, which means
an FM antenna must be connected (see page 16).
22
Red
White
Analog audio cable (RCA)
the Onkyo RI Dock
?
White
Red
cable supplied with
cable allows you to control the RI Dock with the CD
Power cord
Onkyo RI Dock's rear
panel
: Signal flow
cable and an analog audio cable
To wall outlet